Features

 
 
check mark    CORROSION RESISTANT SLANT NOSE DESIGN
check mark     X-MEMBERS OVER 16″ AVG
check mark     WALLS WELDED INSIDE AND OUT
check mark     TRIPLE PASS WELDED HINGES
check mark     FLOOR PLATE JOINTS WELDED 100% TO X-MEMBERS (NOT OVER LAPPED)

Truck Beds

Previous
Next

Prolific Metal Works
Standard Rectangular Roll-off Container Specifications

Floor System 

Note: Floor plates are flush mounted to cross members (not overlapped) providing no gaps between cross members and floor, providing maximum weld penetration.
  • Main Rail:
2″ x 6″ x 3/16″ tubing
  • Floor Struts:
3″ structural channel with cross members based on 16″ centers (average)
  • Floor Gussets:
3/16″ steel plate welded on every cross member
  • Floor Plate:
3/16″ steel panels
  • Hook Plate:
1″ thick steel plate
  • Pull Hook:
1-1/2″ thick CNC cut steel plate
  • Bullnoses:
1-1/2″ thick CNC cut steel plate inserted in main rail
  • Slant Nose:
3/16″ plate with 3/8″ above hook
  • Ground Rollers Rear:
8″ wide 8 5/8″ tall grease fittings in axels
  • Nose Rollers:
4″ wide x 4″ tall with grease fittings in axels

Front Wall

 
  • Wall Panels:
12G steel panels
  • Frame System:
11G tubular construction
  • Front Corners:
Double Welded
  • Side Wall Integration:
Box bent 3/16″ steel plate corner doublers

Side Walls

 
  • Wall Panels:
12G steel panels with (9) formed channel wall posts on 24″ spacing (Nominal)
  • Top Rail:
4″ x 3″ x 11G tubular top rail
  • Tarp Rail & Ladder Rungs:
5/8″ rebar
  • Side Wall Integration:
Box bent 3/16″ steel plate corner doublers

Door

Note: Specifications are subject to change without notice
  • Door Panel:
12G steel panels
  • Frame System:
11G tubular construction
  • Cross Supports:
formed channel
  • Strikers:
8″ x 3/16″ cold-roll with 1/4″ latch retainers
  • Striker Attachment
mounted completely through door frame and fully welded
  • Striker Gussets:
3/16″ formed steel angle
  • Striker Guides:
CNC cut 1/2″ steel plate
  • No of Hinges:
(2-15-20yd) (3-30yd) (3-40yd)
  • Hinge Plates:
9″tall x 11″ wide x 1/2″ thick with 2″ knuckles
  • Hing Pins:
8″ x 3/16″ cold-roll with 1/4″ latch retainers and grease fittings
  • Hinge and Latch Posts:
3/16″ steel box frame
  • No of Latches:
(2-15-20 yd) (3-30 yd) (3-40yd)
  • Latch Construction:
CNC cut 1/2″ steel plate
  • HD Safety Chains:
5/16″ steel
  • EZ Access Chain Brackets:
3/16″ CNC cut and formed angle steel
  • Paint:
Industrial enamel any standard color